Extra-strong double-sided mounting tape for indoor use.
tesa® Powerbond INDOOR is designed for securely mounting flat objects to walls and other firm surfaces without drilling or screws.
• Holds up to 5 kg per 10 cm of tape
• Suitable for objects up to 10 mm thick
• Bonds well to tiles, plaster, wood and most plastics
• Designed for indoor use
• Foam backing helps compensate for minor surface irregularities
Reliable and long-lasting mounting
Under optimal bonding conditions, just 10 cm of tape can hold up to 5 kg.
For best results, apply the tape to a firm, clean, dry and sufficiently smooth surface.
It is suitable for mounting decorations, signs, lettering and other lightweight objects around the home.
How to use
1. Prepare the surface
Remove dust, grease and other dirt. The surface must be clean and dry.
2. Apply the tape
Apply the tape to the rougher of the two surfaces first. When mounting onto a wall or plaster, apply the tape to the wall first.
Vertical strips are recommended along the height of the object. Additional shorter strips can be added near the top, where most of the load is concentrated.
Press the tape firmly for at least 5 seconds.
3. Remove the protective liner
Avoid touching the exposed adhesive surface, as this may reduce bonding strength.
4. Press the object firmly
Position the object carefully and press it firmly against the surface for at least another 5 seconds.
No drilling or additional tools required
No drill, hammer or screws are needed for installation. All you need is a pair of scissors and the required length of tesa® Powerbond INDOOR tape.
Before mounting, make sure the surface itself is strong enough to support the weight of the object.
Removal
tesa® Powerbond INDOOR is designed for permanent, long-lasting adhesion and is not intended to be easily removable.
If removal is necessary, carefully cut through the foam backing using cutting wire and remove the remaining tape.
Important: removing the tape may damage the surface or leave adhesive residue.
